Thick and hard tree knots, branches and wood veneers always crack? Is there any way to soften wood veneer?
Thick and hard tree knots, branches and wood veneers crack when pasted or pressed? The wood veneer is wrinkled and uneven, not properly pasted, leaving the workers at a loss as to where to start? Can't be stuck by machine pressing? Are there any ways to solve the above-mentioned problems?
Fushen Woodworking Glue discovered this difficult problem very early! If a wood veneer softening treatment agent were invented, which would not only not damage the wood veneer texture but also soften and flatten the wood veneer, wouldn't that be an easy solution to the problem?
You guessed it right! Fushen Woodworking Glue has indeed, through dedicated research and development, developed a softener specifically for thick, hard and uneven wood veneers.
It can easily solve this difficult problem!
The product is environmentally friendly and harmless to the human body! Fushen wood veneer softener, after being mixed with water, is applied to the thick and hard wood veneer of tree knots and branches. It is then sealed with cling film and left to stand for 24 hours for softening treatment. Finally, it is flattened through low-temperature hot pressing.
Application of softener
Before softening
