The pressure plate always gets stuck? Choose the right glue, and your efficiency will increase tenfold and your cost will be halved!
In the wooden door pressing board workshop, many factory directors are often troubled by the same pile of problems: they have to wait for 4 to 8 hours for pressing, and even in winter, it takes a whole day. Orders are scheduled until next week but cannot be delivered in time. The freshly packed wooden door was opened by the customer, who found it cracked and had obvious joist marks on it. Complaints about returns kept coming one after another. Workers are constantly busy with the gluing and pressing processes, labor costs are soaring, but production capacity has not increased.
In fact, the root cause of these "roadblocks" that have brought production to a standstill often lies in the most easily overlooked link - the selection of the pressing plate adhesive. The emergence of the GW-2525 cold-pressed adhesive from Fushen Kuai has precisely addressed these pain points, providing a one-stop solution for wooden door factories and fundamentally reversing the production predicament of "low efficiency, poor quality and high cost".
I. Efficiency improvement
Fushen GW-2525 cold-pressed adhesive has achieved breakthroughs in efficiency, quality and cost. In terms of efficiency, it has achieved a "rocket-like" improvement. As a cold-pressed adhesive, it only takes 30 minutes to pressurize in summer and 2 to 4 hours in winter, with an efficiency 8 to 10 times higher than that of ordinary white latex. The open time is long, and multiple boards can be coated at once, eliminating the need for frequent line stops to replenish glue. It has a fast initial strength and can quickly form a stable adhesive force, saving time for subsequent processes. After the Shenzhen wooden Door factory put it into use, the stagnant production rhythm was activated and the daily production capacity was significantly increased.
Second, quality improvement
In terms of quality, it has achieved a comprehensive upgrade. After applying the glue, there will be no cracking of the wooden door or marks on the keel. The defective product rate of this factory has dropped sharply, and returns and complaints have been basically eliminated. It can still form a film normally in a minimum environment of 5℃, without the need for additional temperature control, and is suitable for production in different seasons. Zero formaldehyde addition meets environmental protection standards. It is a one-component glue that can be used immediately after opening the can, eliminating the need for glue mixing steps and reducing operational errors.
Iii. Cost Improvement
In terms of cost, it achieves a significant reduction. Although the unit price is slightly higher than that of ordinary white latex glue, the comprehensive cost has been reduced by more than 50% : the amount of glue applied per square meter is only 100-150g, which is much lower than the 200-300g of ordinary white latex glue. One bucket of glue can coat nearly 110 doors. Efficiency has been increased by five times, human input has been reduced, and labor costs have dropped. The defective rate is low, reducing raw material waste and rework costs. After a trial, a certain factory promptly placed an order for 100 barrels (5 tons).
For wooden door factories troubled by the problem of pressing plates, Fushen GW-2525 is not merely a substitute for glue, but a key tool for reshaping the production process. With its short pressing time, high bonding quality and low comprehensive cost, it helps enterprises solve traditional pain points, achieve a sharp increase in efficiency, stable quality and reduced costs. Choosing it can solve the problem of pressing plates and promote the production of wooden doors to a new level.
Fushen Woodworking Adhesive is a brand of woodworking adhesives under Guangdong Fushen Chemical Co., LTD. It covers water-based environmentally friendly single-component, high-performance wood veneer adhesives, panel gluing adhesives, assembly adhesives, pressing board adhesives, etc., integrating R&D, production and sales. Fushen was founded in 2005 and has been dedicated to the field of woodworking adhesives for many years. It is committed to developing environmentally friendly and high-performance adhesive products to catch up with international professional standards and is hailed by the wood products industry as "China's Expert in wood veneer adhesives".